Free Cisco 200-301 Practice Exam with Questions & Answers | Set: 16

Refer to the exhibit.

Which two commands must be configured on router R1 to enable the router to accept secure remote-access connections? (Choose two)

Refer to the exhibit.

Web traffic is coming in from the WAN interface. Which route takes precedence when the router is processing traffic destined for the LAN network at 10 0.10.0/24?

Refer to the exhibit.

Which plan must be Implemented to ensure optimal QoS marking practices on this network?

Refer to the exhibit.

A company is configuring a failover plan and must implement the default routes in such a way that a floating static route will assume traffic forwarding when the primary link goes down. Which primary route configuration must be used?

Refer to the exhibit.

Which configuration allows routers R14 and R86 to form an OSPFv2 adjacency while acting as a central point for exchanging OSPF information between routers?

A)

B)

C)

D)

Refer to the exhibit.

Packets received by the router from BGP enter via a serial interface at 209.165.201.10. Each route is present within the routing table. Which interface is used to forward traffic with a destination IP of 10.10.10.24?

What is a requirement for nonoverlapping Wi-Fi channels?

Refer to the exhibit.

The router has been configured with a supernet to accommodate the requirement for 380 users on a subnet The requirement already considers 30% future growth. Which configuration verifies the IP subnet on router R4?

A)

B)

C)

D)

Which type of network attack overwhelms the target server by sending multiple packets to a port until the half-open TCP resources of the target are exhausted?

Which two network actions occur within the data plane? (Choose two.)

A network engineer must implement an IPv6 configuration on the vlan 2000 interface to create a routable locally-unique unicast address that is blocked from being advertised to the internet. Which configuration must the engineer apply?

Refer to the exhibit.

An engineer is asked to insert the new VLAN into the existing trunk without modifying anything previously configured Which command accomplishes this task?

Drag and drop the Rapid PVST+ forwarding slate actions from the loft to the right. Not all actions are used.

Refer to the exhibit.

Router R1 resides in OSPF Area 0. After updating the R1 configuration to influence the paths that it will use to direct traffic, an engineer verified that each of the four Gigabit interfaces has the same route to 10.10.0.0/16. Which interface will R1 choose to send traffic to reach the route?

Which WLC management connection type is vulnerable to man-in-the-middle attacks?

Which action is taken by the data plane within a network device?

An engineer is configuring remote access to a router from IP subnet 10.139.58.0/28. The domain name, crypto keys, and SSH have been configured. Which configuration enables the traffic on the destination router?

A)

B)

C)

D)

Refer to the exhibit.

Which route must be configured on R1 so that OSPF routing is used when OSPF is up. but the server is still reachable when OSPF goes down?

Which PoE mode enables powered-device detection and guarantees power when the device is detected?

A Cisco engineer is configuring a factory-default router with these three passwords:

• The user EXEC password for console access is p4ssw0rd1

• The user EXEC password for Telnet access is s3cr3t2

• The password for privileged EXEC mode is pnv4t3p4ss Which command sequence must the engineer configured

A)

B)

C)

D)