Free Cisco 350-501 Practice Exam with Questions & Answers | Set: 11

Drag and drop the technologies from the left onto the correct definitions on the right.

A network engineer is configuring a BGP route policy for the SUBNET prefix set. Matching traffic must be dropped, and other traffic must have its MED value set to 400 and community 4:400 added to the route. Which configuration must an engineer apply?

Refer to the exhibit. Router P4 and P5 receive the 0.0.0.0/0 route from the ISP via eBGP peering P4 is the primary Internet gateway router, and P5 is its Backup. P5 is already advertising a default route into OSPF domain. Which configuration must Be applied to P4 so that advertises a default route Into OSPF and Becomes me primary internet gateway for the network?

What is an enhancement that Cisco IOS XE Software has over Cisco IOS Software?

A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred exit

points for the customer AS?

Refer to the exhibit. All edge routers are fully meshed via the IBGP and IS-IS routing protocols, and LDP is used for label distribution. The network engineer must protect the TE tunnels and MPLS network from interface flaps and retain label information in the LIB cache for 10 minutes. Which action completes the implementation?

Refer the exhibit.

Users on a network connected to router R3 report slow speeds when they connect to the server connected to R2. After analyzing traffic on the network, a network engineer identified congestion on the link between R2 and R3 as the cause. Which QoS service must the engineer implement to drop traffic on the link when it exceeds a configured threshold?

Refer to the exhibit.

Router R1 is reporting that its BGP neighbor adjacency to router R2 is down, but its state is Active as shown. Which configuration must be applied to routers R1 and R2 to fix the problem?

A)

B)

C)

D)

When implementing a REST API, how does an engineer mitigate security risks?

A network administrator must monitor network usage to provide optimal performance to the network end users when the network is under heavy load. The administrator asked the engineer to install a new server to receive SNMP traps at destination 192.168.1.2. Which configuration must the engineer apply so that all traps are sent to the new server?

A network engineer is implementing BFD configuration changes on a customer's equipment. How is the bfd interval configuration on the interface disconnected?

Refer to the exhibit. Users in AS 65010 are connected with the application server in AS 65050 with these requirements:

AS 65010 users are experiencing latency and congestion to connect with application server 172.16.50.10.

AS 65030 must be restricted to become Transient Autonomous System for traffic flow.

Links connected to AS 65020 and AS 65040 are underutilized and must be used efficiently for traffic.

Which two configurations must be implemented to meet these requirements? (Choose two.)

What must a network engineer consider when designing a Cisco MPLS TE solution with OSPF?

Refer to the exhibit. An engineer started to configure a router for OSPF. Which configuration must the engineer perform on the router without changing any interface configuration so that the router establishes an OSPF neighbor relationship with its peer?