Free Cisco 350-601 Practice Exam with Questions & Answers | Set: 6

An engineer configures a role for a new user in Cisco UCS Manager The role should allow the user to configure vHBAs, vNICs, and server port types.

Which role should be assigned to allow the engineer to complete this task?

Refer to the exhibit. In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:

•R1 must be the active RP.

•R2 must be the backup RP that is used only if R1 is not reachable

Drag and drop the configuration steps to complete the configuration for Router 2 Not all configuration steps are used.

A SAN administrator receives reports about latency and response-time issues that impact various applications. The incidents have gradually increased in frequency and seventy and have reached a critical state Which DCNM configuration set identifies the source of the issues?

Refer to the exhibit.

The server is sending traffic to the storage server using Fiber Channel protocol. The requirement is for the N5K-1 to forward traffic to MDS9k-1. Drag and drop the configuration steps from the right to complete the configuration for N5K-1 on the left. Not all configuration steps are used.

Refer to the exhibit. What is the outcome of this command when the EPLD is updated on a Cisco Nexus 9000 Series Switch?

A customer has a requirement to deploy a cloud service and needs to have full control over the underlying OS, data and application. Which cloud model meets this requirement?

What is the impact of upgrading the firmware of the Cisco UCS Manager?

An engineer must assign a device alias of Marketing to a Fibre Channel port that has a world wide name of 21:00:00:00:11:11:22:22 on a Cisco MDS 9000 Series Switch. Which two commands accomplish this goal? (Choose two.)

An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:

Named VSAN must be called "VSAN 10".

VSAN ID must be 10.

FCoE ID must be 20.

VSAN 10 must be attached to port 2 in slot 1.

Which command set configures a VSAN when the fabric interconnect is in Fibre Channel switch mode?

Refer to the exhibit.

An engineer must replace the Fabric Interconnect called UCS-FI LAB1 with the Fabric Interconnect called UCS-Fl LAB2. The new Fabric Interconnect must be restored with the latest configuration of UCS-Fl LAB1. Which backup type must be used to meet this requirement?