Pre-Summer Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 70track

Free Cisco 350-601 Practice Exam with Questions & Answers | Set: 8

Questions 71

350-601 Question 71

Refer to the exhibit. A Cisco data center environment is implemented with vPC. The web server replies using the SVI MAC address as the Layer 2 header instead of the HSRP MAC address on VLAN 23. This behavior causes packet drops on the Cisco Nexus 9000 Series Switches due to the vPC loop prevention mechanism The requirement is for the vPC feature to allow N9K_1 and N9K_2 to forward traffic between the NAS server and the web server, even if the HSRP ' s MAC address is not used on Layer 2 headers for VLAN 23. Which feature must be used to accomplish this goal?

Options:
A.

Peer Gateway

B.

ARP Sync

C.

L3 Peer Router

D.

Object Tracking

Cisco 350-601 Premium Access
Questions 72

350-601 Question 72

Refer to the exhibit. SVR-A in EPG-A/BD-A fails to reach SVR-B in EPG-B/BD-B. Which two conditions should be verified to analyze the traffic between the two EPGs? (Choose two.)

Options:
A.

A contract exists between EPG-A and EPG-B and allows the traffic.

B.

Limit Endpoint Learning is disabled on the bridge domain for EPG-B.

C.

SVR-B is learned as an endpoint in EPG-B from Node-112.

D.

EPG-A and EPG-B are excluded from the preferred group.

E.

The bridge domain for EPG-B floods ARP packets.

Questions 73

An engineer must allow communication between the APIC controller and an OpenStack OpFlex agent. The agent Is running on a compute node directly plugged to a Cisco ACI leaf switch The engineer must enable and extend Intra VLAN on the port facing the compute and extend the Infra VLAN to the host. Which action must be taken to meet these requirements?

Options:
A.

Add the intra VLAN via the physical domain.

B.

Enable the Infra VLAN on the Attachable Access Entity Profile.

C.

Add the infra VLAN via the VMM domain

D.

Enable the Infra VLAN on the Interface Profile policy.

Questions 74

A Cisco Unified Computing System environment must be configured for a server that requites access to VLAN 30 for data and VLAN 40 for management The server must have failover capabilities The upstream connectivity will be provided by using a Cisco Nexus 9000 Series Switch. Which action must be taken to meet these requirements?

Options:
A.

Use a single virtual network interface card for both VLANs and assign the vNlC lo a dynamic LAN pin group.

B.

Create a virtual network interface card for each VLAN and configure the host to use load balancing.

C.

Create a virtual network interface cards for each VLAN and enable vNIC fabric failover

D.

Use a single virtual network interface card for both VLANs and apply a network control policy for prioritization.

Questions 75

A network administrator must create a daily scheduler job on a Cisco Nexus 9000 Senes Switch to back up the device configuration and transfer the backed-up configuration to an external server The backup task must meet these requirements

•The backup file must be saved in a directory named config_backup on the external server •The switch must send an email notification to the administrator when the job is complete

The scheduler job must be configured to run every day at 11 PM Which commands must be run on the switch?

350-601 Question 75

350-601 Question 75

Options:
A.

Option A

B.

Option B

C.

Option C

D.

Option D

Questions 76

350-601 Question 76 Refer to the exhibit.

Which command is run from the Guest Shell to set the

description on the first five interfaces of the Cisco Nexus switch?

Options:
A.

[guestshell@guestshell -]$forx in (1..5); dodohost " conf t " ; " interface eth1/$x " : " description ServerSx " : done

B.

[guestshell@guestshell -]$forx in(1..5); dohost " conf t: interface eth1/Sx ; description ServerSx " ;

C.

[guestshell@guestshe!l -]$ for x in {1.-5}; dohost " conf t; interface eth1/Sx ; description ServerSx " ;

D.

[guestshell@guestshell -]$ for x in {1-0}; do dohost " conf t; interface eth1/Sx ; description ServerSx " ; done

Questions 77

An engineer must implement a VXLAN-based data center Interconnect. The long-distance transport provided by a service provider is IP-based, supports a maximum MTU of 1554 bytes, and does not support outbound traffic replication. Which action must be taken to build the data center Interconnect?

Options:
A.

Implement BGP EVPN Ingress replication

B.

Create an IP access list and associate It with VNI to replicate traffic to remote VTEPs

C.

Announce host reachability over BGP.

D.

Configure a route map to associate the IPs of the remote VTEPs

Questions 78

Refer to the exhibit. An engineer must Implement an Application Performance Monitoring (APM) for the production servers on the Cisco Nexus 93180 Series Switch-based Infrastructure in data center 1. The APM solution must meet these requirements:

    It must copy all inbound and outbound production traffic.

    It must support real-time telemetry.

Which configuration must be used on data center 1 switches to meet these objectives?

350-601 Question 78

Options:
A.

Option A

B.

Option B

C.

Option C

D.

Option D

Questions 79

A network administrator attempts to automate the provisioning of several new Cisco Nexus switches. The administrator prepares a bootstrap configuration script for the task Due to the number of switches a zero-touch provisioning solution is preferred Additionally, some switches arrive with outdated software and should be automatically upgraded as part of the provisioning workflow Which solution meets the requirements?

Options:
A.

DHCP

B.

Ansible

C.

NX-API

D.

POAP

Questions 80

An engineer must analyze packets arriving from a server port on a Cisco Nexus 9000 Series Switch. The packet sniffer is located on a different switch from the one the server is currently connected to. The packet capture must meet these requirements:

    It must capture all incoming packets on the switch port.

    It must capture the first 1000 bytes of the packet to conserve bandwidth.

Which action must be taken to meet these requirements?

Options:
A.

Configure the marker-packet to 1000.

B.

Implement an ACL with the packet-length of 1000.

C.

Enable the MTU size of 1000.

D.

Set rate-limiting to 1000.