Free Cisco 350-601 Practice Exam with Questions & Answers | Set: 5

Which two components should be checked when a Cisco Nexus 9000 Series Switch fails to boot using POAP? (Choose two.)

Refer to the exhibit A network engineer must use a Cisco on-box Python CLI to configure the BGP AS 65501 on Cisco Nexus 9000 Series Switch The output from the command must be returned as raw output instead of JSON format Which command set must be used to complete the configuration?

What is the function of network file storage?

Which storage appliance must be deployed to provide file system access using the NFS protocol?

All logins to a Cisco Nexus 9000 Series Switch must pass through the TACACS+ server at IP address 192.168.10.10. The configuration must meet these requirements:

• The TACACS+ server must be used for SSH and Telnet.

• The TACACS+ server key must be Cisco123!.

• Management VRF must be used for connectivity.

• The deployment must fail back to local credentials if the TACACS+ server fails to respond within 30 seconds.

Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration. Not all code snippets are used.

An engineer must configure HSRP protocol on two cisco nexus 9000 series switches running a virtual port channel in addition, the HSRP implementation must meet these requirements:

Drag and drop the commands from the the right to complete a configuration of the HSRP on the left. The commands are used more than once. Not all commands are used

A cisco mds 9000 series switch must automatically learn about devices and

switches connected to a fibre channel interface. However

a conflicting entry exists in the configuration database.

Which set of actions activates the configuration database?

An engineer is performing a configuration on a Cisco Nexus 5000 Series Switch. The requirement is for the current Fibre Channel IDs in VSAN 120 to be saved across reboots. The Cisco environment also must integrate with a third-party solution that requires persistent Fibre Channel IDs for the VSAN. The WWN of the Cisco switch must be 33:e8:00:05:30:00:16:df and its Fibre Channel ID 0x070128. Which command set meets these requirement?

Refer to the exhibit. VSAN 2077 has been configured as the primary path. Which configuration must be implemented to allow the Cisco UCS system to enable zoning while the device neighbor allows communication using port FC1/24 to the servers?

An engineer must configure device aliases for a Cisco MDS 9000 Series Switches-based SAN fabric. The configuration must meet these requirements:

The engineer must be prompted before the changes are committed to the database

Pending changes must be explicitly displayed on the console.

Which command accomplishes this task?