Free Cisco 300-430 Practice Exam with Questions & Answers | Set: 2

For a network with 3000 APs and 7000 IPS licenses, scaling to a high-end server is appropriate. This will provide the necessary resources and capabilities to support the large number of APs and the extensive licensing requirements for the Intrusion Prevention System.

The output observed in Prime Infrastructure suggests that there is at least one strong interferer impacting connectivity at this site. This conclusion is drawn from observing areas marked with intense red coloring indicating high levels of RF interference which could degrade wireless performance significantly if not addressed. 

Cisco Hyperlocation is enabled in the RF Profile on a Cisco Catalyst 9800 Series Wireless Controller web interface. The RF Profile contains settings that pertain to radio frequency management, which includes the configuration for Hyperlocation.

The Out-of-Sync alarms in Cisco Prime Infrastructure typically indicate that there is a discrepancy between the configuration of the APs as known by Prime Infrastructure and their actual configuration. To resolve this issue, the engineer can either manually synchronize the APs from Cisco Prime Infrastructure (A) or enable automatic synchronization on Cisco Prime Infrastructure © to ensure that the AP configurations are updated automatically. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

When setting up a new Network Access Device (NAD) on Cisco ISE, it is essential to configure the device’s IP address and the RADIUS shared secret. The device IP address is used to identify the NAD within the network, and the RADIUS shared secret is a password used between the ISE and the NAD to ensure secure communication.

In Cisco ISE version 2.1 for BYOD with a Single SSID setup, 802.1x must be configured to provide the necessary layer of security and to facilitate the device registration process. 802.1x authentication allows for the use of EAP (Extensible Authentication Protocol) to authenticate users before they can access the network. This ensures that only authorized devices can join the BYOD network, providing a secure method for device onboarding and access control. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

When implementing Cisco Identity-Based Networking on a Cisco AireOS controller with two ACLs where one is applied directly on the WLC interface and another referenced by ISE for a specific group policy, the resulting ACL for a user in that group would be a combination of both ACLs. The BASE_ACL applied on the corporate_clients interface acts as the default ACL for all corporate clients, while HR_ACL is specific for Human Resources users. When a Human Resources user connects, HR_ACL takes precedence but does not replace BASE_ACL; instead, it appends its rules to those of BASE_ACL resulting in an aggregated set of rules from both ACLs. References := (CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide)

Trusting DSCP is essential for maintaining the QoS markings across the wired and wireless network in a FlexConnect deployment. By trusting DSCP, the WLC and APs will preserve the QoS markings set by applications and devices, ensuring consistent QoS treatment throughout the network. References := (CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide)

 mDNS has specific restrictions regarding its configuration. Option C is correct because mDNS is not supported on FlexConnect APs with a locally switched WLAN, which limits its deployment in certain network designs. Option D is also correct; the controller software must be newer than version 7.0.6 to support mDNS features, which means that older controller software versions do not have the necessary capabilities to handle mDNS. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

 Link-Local Service (LSS) filtering for mDNS (Multicast Domain Name System) is used to control the propagation of mDNS services across the network. To enable LSS for the AppleTV mDNS service only when ORIGIN is set to Wired, the correct action is to set ORIGIN to Wired and enable LSS specifically for the AppleTV service. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide