Free Fortinet FCP_FGT_AD-7.4 Practice Exam with Questions & Answers | Set: 3

The configuration shown in the exhibit indicates that the FortiGate is using a Fortinet-specific RADIUS attribute (Fortinet-Group-Name) with the value "Training." This setup allows the FortiGate to authenticate users against the RADIUS server and match them to the "Training" Organizational Unit (OU). By doing so, only users within this specific group or OU can be authenticated and allowed access through the FortiGate.

References:

FortiOS 7.4.1 Administration Guide: RADIUS Server Configuration

Advanced mode allows for configuration as an LDAP client and supports group filtering directly on the FortiGate, as well as nested or inherited groups.

When SD-WAN is enabled on FortiGate, the load balancing algorithm for Equal-Cost Multi-Path (ECMP) is configured using the load-balance-mode parameter under SD-WAN settings. However, if SD-WAN is disabled, the ECMP load balancing algorithm can be configured under config system settings. This flexibility allows FortiGate to control traffic routing behavior based on the network configuration and requirements.

References:

FortiOS 7.4.1 Administration Guide: ECMP Configuration

By default, SD-WAN members are skipped if they do not have a valid route to the destination

SD-WAN ensures that only members with valid routes to the destination are considered during routing decisions.

By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member

If the best route is not an SD-WAN member, SD-WAN rules are bypassed and standard routing takes over.

SD-WAN rules have precedence over any other type of routes

SD-WAN rules are evaluated first, meaning they take precedence over other routing mechanisms, such as static routes or policy-based routes.

execute ping

This command helps test network connectivity by sending ICMP echo requests to a specified IP address to check if the device is reachable.

execute traceroute

This command traces the route packets take to a destination, which is useful for identifying network hops and potential delays or routing issues.

get system arp

This command shows the ARP (Address Resolution Protocol) table, which is used to map IP addresses to MAC addresses. It's useful for verifying IP-to-MAC address resolution on the network.

For SSL VPN to function correctly between two FortiGate devices, the following settings are required:

B. The server FortiGate requires a CA certificate to verify the client FortiGate certificate: The server FortiGate must have a Certificate Authority (CA) certificate installed to authenticate and verify the certificate presented by the client FortiGate device.

C. The client FortiGate requires a client certificate signed by the CA on the server FortiGate: The client FortiGate must have a client certificate that is signed by the same CA that the server FortiGate uses for verification. This ensures a secure SSL VPN connection between the two devices.

The other options are not directly necessary for establishing SSL VPN:

A. The client FortiGate requires the SSL VPN tunnel interface type to connect SSL VPN: This is incorrect as SSL VPN does not require a specific tunnel interface type; it typically uses an SSL VPN client profile.

D. The client FortiGate requires a manually added route to remote subnets: While routing may be necessary, it is not specifically required for the SSL VPN functionality between two FortiGates.

References

FortiOS 7.4.1 Administration Guide - Configuring SSL VPN, page 1203.

FortiOS 7.4.1 Administration Guide - SSL VPN Authentication, page 1210.