Free CWNP CWDP-304 Practice Exam with Questions & Answers | Set: 6

Omnidirectional antennas should be used to maximize cell overlap.

Use 11 Mbps as the lowest basic rate.

Clients could benefit from RTS/CTS mode for all transmissions.

AP transmit power should be turned down to minimize co-channel interference.

All VoWiFi implementations

Push-to-Talk VoWiFi phones

All VoWiFi soft phones

All VoWiFi hard phones

Vertically polarized omni

60° yagi

Parabolic dish

100° sector

Horizontally polarized omni

mobile apps

console management interfaces

high-data bandwidth application

real-time application

web-based application

This setting allows the site survey software to convert the APs measured downlink RF data into a simulated data set as if the same data

were transmitted by a specific client station. It is useful for determining uplink client performance when clients are located far from APs as

well as projecting cell size for ad hoc networks.

Since WLAN adapters are not typically calibrated by manufacturers, this setting is a form of software calibration in which you can calibrate

an (uncalibrated) adapter to match one of the calibrated adapters shown in the list. This process improves the reliability of RF data collection

and reporting when uncalibrated adapters are used.

This is the configuration area in which you specify the adapter type that will be used for the site survey so that the survey software can

interpret that adapters reported metrics (based on proprietary formulas) into an RF measurement that is standardized by the survey software

and known to its users. This is done

All APs share a virtual Multicast Address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

All APs share a virtual BSSID. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

All APs share a virtual IP address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

The client selects the AP based on a known set of MAC to BSSID mappings stored in the clients authorized SSID listing.

The WLAN controller will place the user priority (UP) value in the QoS Control field of the 802.11 frame header before passing it to the

lightweight AP.

The WLAN controller does not mark 802.11 frames with priority values only the APs can do this.

The WLAN controller does not mark the 802.11 frames with priority values only the Layer 3 switches can do this.

The WLAN controller does not mark the 802.11 frames with priority values only the Layer 3 routers can do this.

All APs share a virtual IP address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from

the client.

All APs share a virtual Multicast Address. A controller will tell the closest AP to the client to communicate with it, since it has a greater

RSSI from the client.

All APs share a virtual BSSID. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the

client.

The client selects the AP based on a known set of MAC to BSSID mappings stored in the clients authorized SSID listing.

Gain appropriate access and clearance to perform the site survey.

Gain meat processing access certification from the FDA.

Ensure that you and your team are using food industry approved USB adapters for the survey.

Just begin the survey, they will understand

Timeline

Personnel

Politics

Budget