Summer Special 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: bestdeal

Free Fortinet FCSS_NST_SE-7.4 Practice Exam with Questions & Answers | Set: 2

Questions 11

Exhibit.

FCSS_NST_SE-7.4 Question 11

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

FCSS_NST_SE-7.4 Question 11

However, the IKE real-time debug does not show any output. Why?

Options:
A.

The administrator must also run the command diagnose debug enable.

B.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

C.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

D.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

Questions 12

Exhibit.

FCSS_NST_SE-7.4 Question 12

Refer to the exhibit, which shows the output of get system ha status.

NGFW-1 and NGFW-2 have been up for a week.

Which two statements about the output are true? (Choose two.)

Options:
A.

If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.

B.

If port 7 becomes disconnected on the secondary, both FortiGate devices will elect itself as primary.

C.

If FGVM...649 is rebooted. FGVM...650 will become the primary and retain that role, even after FGVM...649 rejoins the cluster.

D.

If no action is taken, the primary FortiGate will leave the cluster because of the current sync status.

Questions 13

Exhibit.

FCSS_NST_SE-7.4 Question 13

Refer to the exhibit, which shows a partial web fillet profile configuration.

Which action does FortiGate lake if a user attempts to access www. dropbox. com, which is categorized as File Sharing and Storage?

Options:
A.

FortiGate allows the connection, based on the URL Filter configuration.

B.

FortiGate blocks the connection as an invalid URL.

C.

FortiGate exempts the connection, based on the Web Content Filter configuration.

D.

FortiGate blocks the connection, based on the FortiGuard category based filter configuration.

Questions 14

Exhibit.

FCSS_NST_SE-7.4 Question 14

Refer to the exhibit, which contains partial output from an IKE real-time debug.

Which two statements about this debug output are correct? (Choose two.)

Options:
A.

Perfect Forward Secrecy (PFS) is enabled in the configuration.

B.

The local gateway IP address is 10.0.0.1.

C.

It shows a phase 2 negotiation.

D.

The initiator provided remote as its IPsec peer ID.

Questions 15

Refer to the exhibit.

FCSS_NST_SE-7.4 Question 15

An IPsec VPN tunnel is dropping, as shown by the debug output.

Analyzing the debug output, what could be causing the tunnel to go down?

Options:
A.

Phase 2 drops but Phase 1 is up.

B.

Dead Peer Detection is not receiving its acknowledge packet.

C.

The tunnel drops during rekey negotiation.

D.

The tunnel drops after the timer expires.

Questions 16

Refer to the exhibit.

The exhibit shows the output from using the command diagnose debug application samld -1 to diagnose a SAML connection.

FCSS_NST_SE-7.4 Question 16

Based on this output, what can you conclude?

Options:
A.

Active Directory is used for authentication.

B.

The authentication request is for an SSL VPN connection.

C.

The IdP IP address is 10.1.10.254.

D.

The IdP IP address is 10.1.10.2.

Questions 17

An administrator wants to capture encrypted phase 2 traffic between two FotiGate devices using the built-in sniffer.

If the administrator knows that there Is no NAT device located between both FortiGate devices, which command should the administrator run?

Options:
A.

diagnose sniffer packet any 'udp port 500'

B.

diagnose sniffer packet any 'lp proto 50'

C.

diagnose sniffer packet any 'udp port 4500'

D.

diagnose sniffer packet any 'ah'

Questions 18

Refer to the exhibit, which shows one way communication of the downstream FortiGate with the upstream FortiGate within a Security Fabric.

FCSS_NST_SE-7.4 Question 18

What three actions must you take to ensure successful communication? (Choose three.)

Options:
A.

You must authorize the downstream FortiGate on the root FortiGate.

B.

FortiGate must not be in NAT mode.

C.

Ensure TCP port 8013 is not blocked along the way.

D.

You must enable Security Fabric/Fortitelemetry on the receiving interface of the upstream FortiGate.

E.

Ensure the port for Neighbor Discovery has been changed.

Questions 19

Refer to the exhibit, which shows a partial output of the fssod daemon real-time debug command.

FCSS_NST_SE-7.4 Question 19

What two conclusions can you draw Itom the output? (Choose two.)

Options:
A.

The workstation with IP 10.124.2.90 will be polled frequently using TCP port 445 to see if the user is still logged on.

B.

The logon event can be seen on the collector agent installed on Windows.

C.

FSSO is using DC agent mode to detect logon events.

D.

FSSO is using agentless polling mode to detect logon events.

Exam Code: FCSS_NST_SE-7.4
Certification Provider: Fortinet
Exam Name: FCSS - Network Security 7.4 Support Engineer
Last Update: Jul 14, 2025
Questions: 66
PDF + Testing Engine
$164.99
$66
Testing Engine
$124.99
$50
PDF (Q&A)
$104.99
$42

Fortinet Free Exams

Fortinet Free Exams
Access free Fortinet exam study guides and practice tests at Examstrack. Ensure your success with top-notch preparation resources at Examstrack.