Summer Special 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: bestdeal

Free Cisco 300-615 Practice Exam with Questions & Answers | Set: 4

Questions 31

A Fibre Channel interface on a Cisco Nexus 5000 Series Switch receives bit errors, and the switch disables the interface. A temporary workaround must be implemented before the root cause is identified. Which action does an engineer take to prevent this issue from reoccurring?

Options:
A.

Verify that the SFPs are supported.

B.

Change the SFP to operate at 4 Gbps instead of 2 Gbps.

C.

Run the shutdown and then no shutdown command on the interface.

D.

Run the switchport ignore bit-errors command on the interface.

Cisco 300-615 Premium Access
Questions 32

Refer to the exhibit.

300-615 Question 32

The EEM script fails to send an SNMP trap when a user attempts to enter configuration mode. Which configuration is missing from the script?

Options:
A.

event statement

B.

event-default action statement

C.

policy-default action statement

D.

IP address of the SNMP server

Questions 33

NO: 80

300-615 Question 33

Refer to the exhibit. During a maintenance window of the Nexus switch pair, one of the Cisco Nexus chassis was brought offline for maintenance. The primary Cisco Nexus switch was stable during the maintenance window. After finishing the

tasks on the chassis, the administrator wanted to bring the second switch online. The administrator checked the status of the disconnected switch that was removed from the vPC during the maintenance. The engineer must connect the peer chassis seamlessly with the primary vPC peer without experiencing traffic interruption. Which action accomplishes this goal?

Options:
A.

Change the role priority, then connect the peer switch.

B.

Change the auto recovery to disabled, and enable auto recovery.

C.

Change the auto recovery timer to active if not already set, then re-establish the connectivity.

D.

Change the auto timer to a higher value, then connect the peer switch.

Questions 34

An engineer is troubleshooting a failed DCBX exchange between a server and a Cisco Nexus switch. Which action allows DCBX to successfully negotiate?

Options:
A.

Enable ETS

B.

Enable PFC.

C.

Enable Cisco Discovery Protocol.

D.

Enable LLDP.

Questions 35

Refer to the exhibit.

300-615 Question 35

The initiator that has FC ID 0x970102 fails to communicate with the target that has FC ID 0x970200. What action resolves the issue?

Options:
A.

Reconfigure the initiator and the target to be in the same zones.

B.

Reactivate the zoneset.

C.

Reset the port for FC ID 0x970102 and FC ID 0x970200 to log in to the fabric.

D.

Reset the port for FC ID 0x970209 and FC ID 0x9700c2 to log in to the fabric.

Questions 36

A network engineer notices a sudden interruption to the HSRP adjacency between the switches. The packet loss is reported on the servers for which the default gateway is set as the virtual IP of the HSRP. AII servers on

the VL AN can exchange ping messages. Which configuration set must be applied on the HSRP peers to resolve the adjacency issue?

Options:
A.

key 0 send-lifetime 00:00:00 Oct 01 2018 23:59:59 Sep 01 2020

B.

key 1 send-lifetime 00:00:00 Jun 01 2018 23:59:59 Sep 01 2022

C.

key1 accept-lifetime 00:00:00 Jun 01 2018 23:59:59 Sep 01 2020

D.

key 0 accept-lifetime 00:00:00 Oct 01 2018 23:59:59 Sep01 2020

Questions 37

Refer to the exhibit.

300-615 Question 37

An engineer is performing a health check on ACI. Which statement about interface Ethernet 1/11 is true?

Options:
A.

The interface is working correctly and fully operational, but it is not in use.

B.

The interface policy is misconfigured.

C.

“out-of-service” is the default interface status in ACI.

D.

“out-of-service” indicates that no service graph is in use for this interface.

Questions 38

The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed on the Cisco Nexus switch ports to resolve this issue?

Options:
A.

Turn on lacp suspend-individual.

B.

Turn on lacp graceful-convergence.

C.

Turn off lacp graceful-convergence.

D.

Turn off lacp suspend-individual.

Questions 39

A network engineer experiences the error “DDR3_P1_B1_ECC” when upgrading Cisco UCS firmware. Which action resolves the issue?

Options:
A.

Reset the DIMM

B.

Reset the BMC firmware

C.

Reflash the controller firmware

D.

Reflash the DIMM

Questions 40

What does this adapter output indicate?

adapter 1/6/1 (fls): 2# lunlist 9

vnic: 9 lifid: 6

- FLOGI State : flogi est (fc_id Oxac0e04)

- PLOGI Sessions

- WWNN 50:0a:09:83:8d:53:43:44 WWPN 50:0a:09:83:8d:53:43:44 fc_id 0x000000

- LUN's configured (SCSI Type, Version, Vendor, Serial No.)

- LUN ID: Ox0000000000000000 access failure

-REPORT LUNs Query Response

- Nameserver Query Response

-WWPN: 54:b1:6a:94:64:3e:73:44

Options:
A.

The configured initiator LUN ID does not match the configured target LUN ID

B.

The target device configuration does not allow the initiator to access the LUN

C.

The port types between the target and initiator are incorrectly configured

D.

The target of the configured zone does not match the target of the configured boot order

Exam Code: 300-615
Certification Provider: Cisco
Exam Name: Troubleshooting Cisco Data Center Infrastructure (300-615 DCIT)
Last Update: Jul 15, 2025
Questions: 167