Free Cisco 300-415 Practice Exam with Questions & Answers | Set: 7

An engineer must configure local redundancy on a site. Which configuration accomplish this task?

If Smart Account Sync is not used, which Cisco SD-WAN component is used to upload an authorized serial number file?

A company deploys a Cisco SD-WAN solution but has an unstable Internet connection. When the link to vSmart comes back up, the WAN Edge router routing table is not refreshed, and some traffic to the destination network is dropped. The headquarters is the hub site, and it continuously adds new sites to the SD-WAN network. An engineer must configure route refresh between WAN Edge and vSmart within 2 minutes. Which configuration meets this requirement?

Which protocol is used to measure loss latency, Jitter, and liveliness of the tunnel between WAN Edge router peers?

Which type of lists are used to group related items via an application-aware routing policy under the policy lists command hierarchy on vSmart controllers?

What problem happens on a device with two serial numbers, a unique device identifier (UDI), and secure unique device identifier (SUDI) when an engineer provisions ISR 4000 by PnP using only a UDI?

An engineer modifies a data policy for DIA in VPN 200 to meet the requirements for traffic destined to these locations:

* external networks; must be translated

* external networks; must use a public TLOC color

* syslog servers, must use a private TLOC color

Here is the existing data policy configuration:

Which policy configuration sequence set meets the requirements?

Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?

Which VPNs must be configured outside the workflow to complete the SD-WAN overlay setup when using the Quick Connect workflow?

How is the scalability of the vManage increased in Cisco SD-WAN Fabric?