Weekend Special Sale 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: sale75best

Free Huawei H35-831 Practice Exam with Questions & Answers

Questions 1

Which of the following represent the primary functions of BGP-LS in Huawei SRv6 Policy?

Options:
A.

Delivers BGP routes.

B.

Advertises the SRv6 Policy status.

C.

Collects topology/prefix information.

D.

Delivers SRv6 Policy information.

Huawei H35-831 Premium Access
Questions 2

Which vBRAS communication channel is used to carry forwarding-control data sent from the vBRAS-CP to the vBRAS-UP?

Options:
A.

Forwarding channel

B.

Protocol channel

C.

Management channel

D.

Control channel

Questions 3

Which of the following statements is incorrect regarding SRv6 protection technologies?

Options:
A.

In an SRv6 TE Policy scenario, if a specified explicit node fails, TI-LFA cannot be used to restore services.

B.

TI-LFA can be used in both SRv6 BE and SRv6 TE Policy scenarios.

C.

In an SRv6 TE Policy scenario, after headend-based fault detection is configured, the device sets the segment list to down and deletes the segment list entry as long as more than two SRv6 SIDs in the segment list do not exist in the topology.

D.

In an L3VPN scenario, if traffic is carried over an SRv6 TE Policy, both egress protection and VPN FRR can protect PEs.

Questions 4

In the inter-AS VPN Option A network shown, CE1 and CE2 are in the same VPN. LDP and IGP are configured in both AS100 and AS200, and EBGP is configured between the ASBRs. CE1’s loopback interface is assigned 10.1.1.1/32. If CE2 can ping CE1, which router assigns the inner label to CE2-to-CE1 packets forwarded by PE2?

H35-831 Question 4

Exhibit 45.1 — Original topology/configuration figure

Options:
A.

ASBR1

B.

ASBR2

C.

P2

D.

P1

E.

PE1

Questions 5

Which of the following statements regarding the telco cloud network are correct?

Select all that apply.

Options:
A.

If two DC GWs are single-homed to PEs, you are advised to adjust route preference in a way that traffic from the two DC GWs uses different PEs as next hops. Otherwise, one PE may become overloaded.

B.

If the management & storage network and service network are deployed independently, they are physically isolated. If one network is attacked, the other network continues to run as usual, ensuring overall security.

C.

The service network uses the flattened spine-leaf architecture to provide high bandwidth, elastic scalability, and flexible access.

D.

As the telco cloud network expands, some sites that use box-shaped devices as DC GWs may fail to meet the bandwidth requirements of north-south service traffic, yet carriers may not want to replace existing DC GWs with high-capacity ones. In this case, the egress bandwidth of the telco cloud network can be increased by adding more DC GWs.

Questions 6

Which of the following statements are correct regarding the reliability of MVPNv4 over BIERv6?

Select all that apply.

Options:
A.

To improve the reliability of the multicast solution, it is advisable to plan separate paths for the primary and backup tunnels.

B.

In the 1+1 dual-root protection solution, the multicast source sends multicast packets to receiver PEs through both primary and backup tunnels. However, only the packets on the primary tunnel are sent to the private network.

C.

In the 1+1 dual-root protection solution, if traffic on the primary tunnel is interrupted and a leaf node PE detects this interruption, t he leaf node PE immediately checks whether the traffic on the backup tunnel is normal. If the traffic is abnormal, the leaf node PE resends a C-multicast route to initiate a VPN user join request.

D.

MVPNv4 over BIERv6 supports 1+1 dual-root protection.

Questions 7

Which of these statements are correct regarding IS-IS reliability parameters on a 5G transport network?

Select all that apply.

Options:
A.

It is recommended that you set the maximum delay, initial delay, and each incremental delay to 1s, 50 ms, and 50 ms respectively for the SPF calculation timer.

B.

It is recommended that you enable TI-LFA and deploy microloop avoidance.

C.

It is recommended that GR be enabled so that the neighbor status and database remain unchanged after the neighbor relationship is disconnected.

D.

It is recommended that you set the maximum delay, initial delay, and each incremental delay to 1s, 50 ms, and 50 ms respectively for the LSP generation timer.

Questions 8

iFIT is an in-band flow-measurement technology that delivers highly precise performance measurements based on real traffic. Which functions can it provide when used with telemetry, a second-level data-collection technology, and NCE, an integrated management and control platform?

Select all that apply.

Options:
A.

Network redundancy protection

B.

Fast fault demarcation and locating

C.

Real-time network quality visualization

D.

Proactive monitoring

Questions 9

Which of the following SIDs encapsulates the outer destination address for BIERv6 multicast packets?

Options:
A.

End.BIERv6 SID

B.

End.DT6 SID

C.

End.DX6 SID

D.

End.BIER SID

Questions 10

When synchronizing LSDBs over a P2P network, IS-IS does not need to send CSNPs.

Options:
A.

TRUE

B.

FALSE