Free Cisco 500-220 Practice Exam with Questions & Answers | Set: 2

https://documentation.meraki.com/MI/MI_Web_App_Health/Overview#:~:text=On%20this%20page%2C%20you%20can,that%20ports%20cannot%20be%20specified .

https://documentation.meraki.com/MV/Advanced_Configuration/Scheduled_Recording

By default, the Meraki security camera's will record continuously 24/7. In some situations, certain times of day are not allowed to be recorded. Scheduled recording covers this requirement as well as improve the video retention capabilities of the camera.

SM Sentry enrollment can be enabled on any MR network via the Splash page section of the Wireless > Configure > Access control page. https://documentation.meraki.com/MR/MR_Splash_Page/Systems_Manager_Sentry_Enrollment

https://documentation.meraki.com/MR/MR_Splash_Page/Systems_Manager_Sentry_Enrollment

This is the approximate number of APs that are needed based on client count, assuming that each AP can support up to 25 concurrent video streaming users. This can be calculated by using the formula:

Number of APs = (Number of Users x Percentage of Users on a Band) / Number of Users per AP on that Band

Where Number of Users is 100, Percentage of Users on 2.4 Ghz is 30%, Percentage of Users on 5 Ghz is 70%, Number of Users per AP on 2.4 Ghz is 15, and Number of Users per AP on 5 Ghz is 30. Therefore,

Number of APs = (100 x 0.3 / 15) + (100 x 0.7 / 30) Number of APs = (3.33) + (2.33) Number of APs = 5.66

Rounding to the nearest whole number, the number of APs is 4.

This question is related to the topic of Wireless Capacity Planning in the Cisco Meraki documentation. You can find more information about this topic in the [Wireless Capacity Planning] article or the [Best Practice Design - MR Wireless] page.

https://documentation.meraki.com/SM/Monitoring_and_Reporting/Selective_Wipe_and_Device_Quarantine_in_Systems_Manager

Meraki MR Access Points, in combination with a wireless profile installed on the iOS device, will enable the Fast Lane technologies. The fastest way to install a wireless profile on an iOS device is via Meraki EMM. https://documentation.meraki.com/MR/Wi-Fi_Basics_and_Best_Practices/Wireless_QoS_and_Fast_Lane

IOS:

• Kiosk mode
• Single App mode
• Wallpaper
• Cisco Security Connector
• Active Sync

Android:

• Kiosk mode
• Backpack
• Wallpaper
• Active Sync

This question is related to the topic of System Manager: Getting Started in the Cisco Meraki documentation. You can find more information about this topic in the [System Manager: Getting Started] article or the [System Manager Overview] page.

https://documentation.meraki.com/SM/Profiles_and_Settings/Configuration_Settings_Payloads

https://documentation.meraki.com/MS/Layer_3_Switching/MS_Warm_Spare_(VRRP)_Overview

The performance probe is a small payload (approximately 100 bytes) of UDP data sent over all established VPN tunnels every 1 second. MX appliances track the rate of successful responses and the time that elapses before receiving a response. This data allows the MX to determine the packet loss, latency, and jitter over each VPN tunnel in order to make the necessary performance-based decisions.

https://documentation.meraki.com/Architectures_and_Best_Practices/Cisco_Meraki_Best_Practice_Design/Best_Practice_Design_-_MX_Security_and_SD-WAN/Meraki_SD-WAN#Performance_Probes