Free Huawei H19-424_V1.0 Practice Exam with Questions & Answers | Set: 2

For the Locator CIDR block planning of SRv6, the appropriate mask should be set according to the number of IPv6 SIDs that may be used by the device.

loatos svV6_locator ipu6-prelix21.DB8ABCD: .b4 static 32, Locator is 2001.DB8.ABCD:, length 64 bits, static segment occupies 32 bits, dynamic segment occupies 32 bits args field occupies O bits. The starting value of the state segment is: 2001:DB8:ABCD:0000:0000:0000:C

Locator SID supports static configuration or dynamic allocation, end-op and end-m must be statically configured, and static configuration is also recommended for end and end.x, which is convenient for network O&M. Other SIDs can be assigned dynamically.

Devices at the same site belong to the same large network segment with the same prefix, and different devices are assigned to the small network segment with the same prefix in the large network segment.

Provide wireless terminal access function

Establish a MESH connection

Each radio can be configured with multiple radio resources, and the number is unlimited

Each radio can be configured with only one

In the overlay interconnection solution, it is recommended to run the VRRP VRRP virtual address between the two borders as the gateway for wireless users

During wireless centralized forwarding, the WAC and the border need to manage IP communication and service VLAN communication, that is, the underlay and overlay need to be connected.

During wireless local forwarding, only the management IP address needs to be communicated between the WAC and the border, that is, the underlay is connected.

Supported networking: WAC dual-node hot standby (VRRP dual-node hot standby or dual-link hot standby), and dual-border port sub-networking, recommended dual-node VRRP hot standby: In multi-campus interconnection LAN-WAN convergence scenarios, refer to the following topology

If the Flag value of the migration attribute in the MAC address route is 1, it indicates a static MAC address, and the static MAC address is preferred.

When a MAC address route is migrated, the large sequence number in the MAC migration attribute is preferred.

and MAC address routes are filled with two labels (that is, both mplslable1 and mplslable2 are valid in packets).

The Route Distinguisher value (RD value) of the MAC route is generated by the value configured by the evpn source-address

Data processing node FI

Authentication node ACA

Data acquisition node ACC

Register the inquiry center

Device management node ACM

Maintain the principle of uniformity in the scheduling strategy of the whole network, and use templated deployment as much as possible to facilitate network management

LPQ/WFQ scheduling strategies can be used to avoid low-priority services not being able to obtain bandwidth resources

The current QoS policy needs to take into account the subsequent expansion of the network

Core services and video-voice services should ensure the absolute priority of forwarding and use PQ scheduling

Unless the business has special requirements, some parameters of the scheduling policy should be defaulted as much as possible

For TCP-based services, the queue must be configured with WRED dropping to avoid TCP global synchronization

Local hardware redundancy protection

TE HSB

Local software protection

Remote disaster recovery

The ARR20 version was released.

Support DSVPN feature

Industrial access router.

Fanless design

Load sharing

VPN FRR

PCEP

TE HSB

Netconf

HTTP

HTTP2.0

HTTPS