Free Cisco 300-815 Practice Exam with Questions & Answers | Set: 5

A new solution is configured to support internal, local, and international calling. Calling [+44 1111 1111] from one of the registered internal phones does not work. Local and internal calls seem to work without any problems. The configuration has patterns configured to match the failing dialed number [+44 …. ….]. The other configured patterns show [2…] for internal numbers and [555 …] for local numbers. International numbers use E.164 as recommended. What is missing to make this solution work?

You see the voice register pool 1 command in your Cisco Unified Communications Manager Express configuration. Which configuration is occurring in this section?

What are two functions of the metadata in SIP recording? (Choose two.)

Which set of commands binds SIP media and signaling to interface GigabitEthernet0/0 when dial peer 1 is chosen for call routing?

Refer to the exhibit.

A collaboration engineer is troubleshooting an issue where the PSTN calls of a Cisco UCM IP phone user are not reaching the PSTN gateway. Which action resolves the issue?

An IP Telephony administrator is deploying IP phones The administrator has an existing Cisco UCME router with several SCCP & SIP phones registered. The administrator receives a request for a new SIP phone with MAC address 1111 2222.3333 and directory number 2050 to be added in the Cisco UCME. Which two configurations should be added in CME to support this request? (Choose two )

Refer to the exhibit. This message is sent to the device being placed on hold for the Music On Hold audio setup. The held party reports receiving dead air rather than music when the call was put on hold. The software Music On Hold server on Cisco UCM is used in this scenario. Assume that the audio leg between the Music On Hold server and the held device uses G.711, and the relevant region relationship is configured for 64 kbps. What is the cause of the issue?

A newly deployed site in Pennsylvania uses SIP-to-SIP legs on a Cisco Unified Border Element. The administrator wants to match the incoming dial peer based on the calling number. Which configuration is needed in the dial-peer?

Which two types of distribution algorithm are within a line group? (Choose two.)

An engineer is troubleshooting an intersite call between two endpoints where the call fails and the message “Not Enough Bandwidth” is displayed. G.729 codec is in use on both sites. First, calls are being properly routed, and the issue happens after the third call is established and the bandwidth utilization between the two sites is under 50%. Which configuration in Cisco UCM must be adjusted to resolve the issue?