Black Friday Special 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: sale65best

examstrack slider

Effective Study Techniques for the Huawei H35-560 Exam

Questions 1

The single-station verification test only needs to verify whether the cell status in the idle mode is normal.

Options:

A.

True

B.

False

Buy Now
Questions 2

Which of the following carrier bandwidths does LTE support? (multiple choice)

Options:

A.

40M

B.

5M

C.

15M

D.

20M

Buy Now
Questions 3

Which of the following is not a weak coverage solution?

Options:

A.

adjusteNodeBTransmit power

B.

Adjust the antenna azimuth and downtilt angle, increase the antenna height, and replace the high-altitude wire, etc.

C.

Adjust neighbor relations

D.

Check whether the room sub-system or repeater is working normally, and check whether there is other radio interference

Buy Now
Questions 4

In the newly-built two-channel indoor sub-system, because LTE uses the MIMO feature, the uplink and downlink rate of the two-channel indoor sub-system is twice that of the single-channel indoor sub-system.

Options:

A.

True

B.

False

Buy Now
Questions 5

Which of the following reference signals are available in both LTE TDD and FDD LTE systems? (Multiple choice)

Options:

A.

Cell specific RS

B.

UE specific RS

C.

Uplink reference signal DM RS

D.

Uplink reference signal SRS

Buy Now
Questions 6

Which of the following is the correct description of the following LTE neighboring cell planning? (Multiple choice)

Options:

A.

Geographically directly relatedNeighboring cells are generally used as neighboring cells

B.

For dense urban areas and ordinary urban areas, the distance between stations is relatively close (0.3-1.0kilometer),Neighborhood should do more

C.

becauseforLTEofThe neighboring area does not exist in orderI,CanProblem, and the detection cycle is very short, so you only need to consider not missing neighbors, not wantSort neighboring cells strictly according to signal strength

D.

ANRThe function can completely replace the initial networkNeighbourhood planning

Buy Now
Questions 7

LTE can obtain various interface signaling through LMT, M2000, and drive test tools.

Options:

A.

True

B.

False

Buy Now
Questions 8

In the mobile communication system, what are the commonly used interference suppression methods? (multiple choice)

Options:

A.

Increase protective belt

B.

Apply to change frequency band

C.

Increase the isolation between antennas

D.

Install filter

Buy Now
Questions 9

Regarding the over-zone, overlapping coverage control, which of the following statements is wrong?

Options:

A.

Station height control: strictly control the station height to avoid over-zone interference

B.

Station spacing control: strictly avoid overlapping coverage sites within 100m

C.

Topological structure planning: the site distribution is as uniform as possible

D.

The angle of the sector in the station should be kept as close as possible to 60 degrees, direct sparring between stations can enhance coverage

Buy Now
Questions 10

In mobile communication systems, there are usually two ways to define/obtain KPL: eNodeB performance statistics and drive test tools for drive test.

Options:

A.

True

B.

False

Buy Now