Ace the Nokia 4A0-104 Exam: Ultimate Preparation Guide

Each router requires 1 VPLS service.

Each router requires 2 VPLS services.

Each router requires 1 SDP with 2 LSPs, one to each of the other 2 routers.

Each router requires 2 SDPs.

Each router requires 3 SDPs

The vc-id on the mesh-sdp must be explicitly configured.

The vc-id on the mesh-sdp is automatically assigned by a PE using the service id.

The VPLS service id, on all PE routers, does not have to match.

The VPLS service id, on all PE routers, must match.

If dynamic signaling is required, the signaling on all PE routers must be set to TLDP in the configuration of the SDPs.

The signaling on all PE routers will default to TLDP in the configuration of the SDPs; therefore, no configuration change is required for dynamic signaling.

1

4096

None. This encapsulation is not supported.

The number is limited only by the capacity of the router

VPLS supports point-to-point connections.

VPLS supports multipoint-to-multipoint connections

VPLS supports a distributed service

VPLS supports a local service on a single node.

Dot1Q

Q-in-Q

ATM

NULL

Nil

vc-type null

vc-type ether

vc-type vlan

vc-type none

TRUE

FALSE

OSPF

RIP

BGP

IS-IS

IES does not support QoS.

IES has a configurable IP-MTU

A virtual route table must be configured for an IES service.

An IES interface has an IP address assigned to it.

Layer 3direct Internet access service

Layer 2 point-to-point service

Layer 2 multipoint-to-multipoint service

Layer 3 IP multipoint-to-multipoint VPN service