How to Pass the Oracle 1z0-404 Exam: Comprehensive Oracle Communications Session Border Controller 7 Basic Implementation Essentials Guide and Tips

A reboot is always required to apply any change to the boot parameters.

The target name is used for domain name resolution.

The system clock is a boot parameter.

The boot parameters are stored in Non-Volatile Random Access Memory (NVRAM).

The boot parameters are not affected by the activate-config command.

The Session Border Controller does not allow more than one configuration session within 24 hours.

The Session Border Controller does not support Telnet/SSH timeouts.

The Session Border Controller supports only one simultaneous configuration session, and the Telnet/SSH timeouts are set to 0.

The Session Border Controller supports only 10 simultaneous configuration sessions.

The Session Border Controller supports only five simultaneous Telnet/SSH sessions.

Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

Navigate to the phy-interface configuration element and configure the hip-id parameter.

Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

Navigate to the network-interface configuration element and configure the name parameter.

It sends a periodic re-register command to each endpoint behind a NAT.

It creates a binding for the Address of Record (AOR) of an endpoint that is behind a NAT.

It creates a binding for the Address of Record (AOR) of an endpoint that is NOT behind a NAT.

It sends SIP OPTIONS at increasing intervals to test if an endpoint behind a NAT device is still reachable.

It sends ICMP PNGs to dynamically learn the binding time of an endpoint behind a NAT device.

from the superuser mode, by executing the remove user command

from the user mode, by executing the kill command

from the superuser mode, by executing the remove user command

from the superuser mode, by executing the kill command

from the user mode, by executing the remove user command

The Hosted NAT Traversal (HNT) architecture focuses on the border point between two different service provider networks, both in the home realm.

The Hosted IP architecture focuses on the border point between one enterprise network realm and one service provider network realm.

The Access-backbone architecture focuses on the border point between two backbone realms.

The Peering architecture focuses on the border point between two different service provider networks and their realms.

The Gateway architecture Focuses on the border point between one enterprise network realm and one service provider network realm.

The ACK method was defined only in RFC 2543 and it has been deprecated.

The ACK method is part of the INVITE transaction.

The ACK method is an exception in RFC 3261.

The ACK method is an optional SIP method.

The ACK method was replaced with the CANCEL method in RFC 3261.

Add the IP address of the remote device to the hip-ip-list and ftp-address parameters.

Set the ftp-address parameter to enabled.

Add the IP address of the interface in the hip-ip-list and ftp-address parameters.

Set the hip-address parameter to enabled.

Add the IP address of the interface in the hip-ip-list and telnet-address parameters.

From configuration mode, execute the done command.

From superuser mode, execute the write-config command.

From user mode, execute the save-config command.

From user mode, execute the commit-config command.

From superuser mode, execute the save-config command.

The deletion is lost on immediate reboot.

The deletion is reflected when viewing the running configuration.

The deletion takes effect immediately in the saved configuration.

The deletion always requires a reboot to take effect.

The deletion requires auto-save enabled.