Get Certified: Proven Methods to Pass the Brocade 150-820 Exam

You have formed a Brocade VCS Fabric. The fabric has four RBridges.

sw11# show vcs

Config Mode : Local-Only

VCS ID : 101

Total Number of Nodes : 4

Rbridge-Id WWN Management IP Status HostName

--------------------------------------------------------------------------------

11 10:00:00:05:33:55:64:B3* 10.255.245.7 Online "VDX11"

12 >10:00:00:05:33:55:5F:73 10.255.245.8 Online "VDX12"

13 10:00:00:05:33:91:4A:0B 10.255.245.29 Online "VDX13"

21 10:00:00:05:33:55:5D:F3 10.255.245.12 Online "VDX21"

Referring to the exhibit, which RBridge ID shown in the output is the principal RBridge?

Referring to the exhibit, you are experiencing latency issues on interface Te 27/0/60.

switch# show interface tengigabitethernet 27/0/60

TenGigabitEthernet 27/0/60 is up, line protocol is up (connected)

Hardware is Ethernet, address is 0005.3367.26d8

Current address is 0005.3367.26d8

Pluggable media present

Interface index (ifindex) is 283874428169

MTU 2500 bytes

LineSpeed Actual : 10000 Mbit

LineSpeed Configured : Auto, Duplex: Full

Flowcontrol rx: off, tx: off

Last clearing of show interface counters: 22:07:59

Queueing strategy: fifo

Receive Statistics:

15254 packets, 1395269 bytes

Unicasts: 10641, Multicasts: 2637, Broadcasts: 1976

64-byte pkts: 10874, Over 64-byte pkts: 3294, Over 127-byte pkts: 117

Over 255-byte pkts: 969, Over 511-byte pkts: 0, Over 1023-byte pkts: 0

Over 1518-byte pkts(Jumbo): 0

Runts: 0, Jabbers: 0, CRC: 1128350, Overruns: 0

Errors: 1128350, Discards: 0

Transmit Statistics:

12633 packets, 1155963 bytes

Unicasts: 18, Multicasts: 12615, Broadcasts: 0

Underruns: 0

Errors: 0, Discards: 0

Rate info (interval 299 seconds):

Input 0.000128 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Time since last interface status change: 0d00h40m

What are two reasons for the problem? (Choose two.)

You want to protect your Brocade VCS Fabric from excessive multicast traffic.

Which two features would you enable? (Choose two.)

Which two statements are true about a Brocade VCS Fabric operating in logical chassis mode? (Choose two.)

Referring to the exhibit,

to minimize downtime, what is the Brocade recommended approach to fabric node upgrades?

You are asked to deploy servers with a single adapter that is attached to your Brocade VCS Fabric to communicate with FC SAN attached storage.

Which two components are required? (Choose two.)

According to Brocade best practices, which management utility should be used in a Brocade VCS Fabric?

You want to allow help desk personnel to enable or disable only the 10 Gbps interfaces using CLI.

Which feature in Brocade NOS would you configure?

You want to create an aggregated link to a hypervisor that does not support LACP.

What is the mode that needs to be configured on the channel group?

In the exhibit, both MAC addresses are assigned to interface 2/0/4.

What does the (UC) indicate?